Fast shipping to the Baltics and across the EU

Variator Parts

45 products

Variator parts for Minarelli, Piaggio/Gilera and Peugeot engines: primary (outer) variator drive faces, fan drive faces with cooling vanes and washers. The catalogue has 45 products from €3.50 – Stage6 CNC Racing Drive Face, Malossi Ventilvar and Ventilvar MHR, Polini Air Speed, Carenzi, plus standard TNT, RMS and OEM drive faces. Minarelli parts are split by crankshaft diameter (13 mm or 16 mm), Peugeot into vertical and horizontal engine versions. For the larger Piaggio / Gilera 125–180 cc two-strokes there's an RMS drive face with 78 teeth. Items are stocked in Kaunas and dispatched within 1–2 working days.

Good to know

Primary drive face and fan

The primary drive face is the outer, fixed half of the variator; the drive belt runs between it and the moving half. On many scooters it also doubles as the fan that cools the belt and the variator cover, which is why performance versions such as the Malossi Ventilvar have more efficient vanes.

Crankshaft and kick-start teeth

The drive face fits onto the crankshaft splines, so both the diameter and the spline profile must match. Minarelli engines come in 13 mm and 16 mm crankshaft versions, Peugeot in vertical and horizontal engine versions. On many scooters the drive face also carries the kick-start gear ring, so the number of teeth matters.

How to spot wear

Over time, grooves or a step develop on the surface where the belt runs. Such a surface wears the belt and stops it sliding smoothly, so the scooter starts to judder. If the kick-start ring is worn too, the starter may slip or rattle.

Washers and fitting

Stage6 washer sets contain shims 0.4–1 mm thick – they're used to change the variator spacing and the belt position. Tighten the drive face nut firmly using a variator holder, and check beforehand that there's no dirt or oil between the drive face and the crankshaft.

Frequently asked questions

Which drive face fits my Minarelli – 13 or 16 mm?

It depends on the crankshaft: the catalogue has versions for a 13 mm crankshaft and for a 16 mm crankshaft, which is more common on Minarelli copies. Measure the end of the crankshaft with a vernier calliper or send us your model.

Does a CNC drive face improve the ride?

A CNC-machined drive face is smoother and more precise, so the belt slides more evenly and cooling is more efficient. The difference is most noticeable when replacing a worn standard drive face or tuning the whole transmission.

Why is there a rattle from the variator side?

The most common causes are worn variator rollers, a loose drive face nut or damaged kick-start gear teeth. Check the variator straight away, as a loose drive face can damage the crankshaft splines.

Can a primary drive face be used with a different variator?

Usually yes, as long as it's made for the same engine and crankshaft. That said, some performance variators have their own drive face or require washers, so check the variator manufacturer's instructions.