In stock−10%Single
12 products
Individual stickers for when you do not need a whole sheet or set: Stage6, YASUNI, PIAGGIO and the holographic DVITAKTIS sticker, 7 mm wheel rim tape in five colours, and a film for Aprilia SR Factory forks. You will find 12 products from €3.00 here, from str8, STAGE 6, Piaggio, YASUNI and Aprilia. YASUNI stickers come in two sizes – 170x38 mm and 110x25 mm – so it is easy to pick one to suit the spot on your bodywork. Stickers in stock are sent to your chosen parcel locker within 1–2 working days.
Good to know
Applying wheel rim tape
Rim tape is applied to the edge of the rim, running around its circumference. Wash and degrease the rim, then lay the tape slowly, keeping it under slight tension so it stays straight. It is easiest with the wheel removed or turning slowly, and trim the ends of the tape with a sharp craft knife at the valve.
Fork film
The film is made for Aprilia SR Factory forks and is applied to their round surface. Clean any oil and dirt off the forks before applying, and stretch the film on after warming it with a hair dryer – that way it lies flat without wrinkles. The seam is best left at the back of the fork, where it is less visible.
Where to put a single sticker
Place the sticker on a flat, gently curved area where it will not be rubbed by your feet, a bag or the seat – a sticker that gets rubbed wears out quickly. Avoid areas near the exhaust pipe and engine, where the plastic gets very hot. Before peeling off the backing paper, mark its position with masking tape.
Frequently asked questions
Does the rim tape suit scooter wheels?
Yes, the 7 mm tape works on small scooter rims as well as larger motorcycle wheels. The edge of a small-diameter rim takes some patience – apply the tape in short sections and press it down often.
What colours does the rim tape come in?
The catalogue has rim tape in blue, white, orange, red and green. All of it is 7 mm wide and 9 m long, so one roll is usually enough for more than one wheel.
What is the DVITAKTIS holographic sticker?
It is our shop's own sticker with a holographic effect that changes colour depending on the angle of the light. You can put it on your scooter's bodywork, a toolbox or any other flat surface.
Why did my sticker peel off after a few days?
Usually because the surface was not degreased or the sticker was applied in the cold. For the first few days after applying it, do not wash the scooter with a pressure washer, so the adhesive has time to bond properly to the plastic.











